Built for Nanaimo's housing, not generic suburbia.
Nanaimo's housing mix makes heat pump design local work. Older Harewood, Old City and downtown homes often run oil or baseboards on 60 to 100 amp panels, so the electrical upgrade (rebated up to $5,000 on qualifying income-tested conversions) is planned into the same project by our own electricians. Hillside and Departure Bay view homes with big glass need honest load math rather than a rule of thumb. Newer North Nanaimo and Lantzville builds usually take multi-zone ductless cleanly, and Cedar acreages are where we see the most oil-to-heat-pump conversions, which happen to carry the largest rebates.
What is in every Nanaimo install
- A CSA F280-12 heat-load calculation, required by BC's rebate programs and the reason our systems do not short-cycle or underheat.
- Tosot and Fujitsu cold-climate equipment, every quoted combination verified on the official qualified-product list so the rebate math survives.
- Composite pads, proper risers, tidy lineset covering and condensate routed properly, as standard.
- Electrical by our own Red Seal electrician: panel, circuits, disconnects, one inspection.
- Rebate screening, program guidance, and the income-qualified rebate deducted from your invoice up front.
- Commissioning, airflow setup and a walkthrough so you actually know how to run it.
